RebarCalc Pro

RebarCalc Pro is a field notebook for comparing a reinforced-concrete beam. Four tabs take one member from the section to the report: Section, Loads, Verify, Reports. The interface is English. Data stays on this device. Change width, height, or cover, edit bar count, or drag a point load along the span, and the moment, shear, and section preview update. This is a record-and-compare tool. Forces and steel quantities are estimates from the span, loads, and bars you enter. The phone does not pass or fail a code check, and it does not issue a signed calculation. 01 Section Open the section desk (sample Riverside Office, member B-01, span 6 m, section 300 × 600 mm, cover 35 mm). Edit width, height, and cover, keep the simply supported model, and open geometry, materials, and the section library. 02 Loads Open the load desk. The sample includes LC-01 Permanent, LC-02 Imposed, and LC-03 Maintenance. Drag the orange point load along the beam, or add a uniform, point, or patch load. Cases stay independent. Combination factors are the ones you enter. 03 Verify Open verification. Read moment and shear for the current geometry, materials, and loads, beside the bar layout. Change bottom-bar count and diameter, and open the flexural trace, shear model, serviceability, bar geometry, stirrup zones, candidates, assumptions, and a revision snapshot. 04 Reports Open the calculation report. Export a PDF preview, DXF, or CSV from the current revision. The report records the model, units, and assumptions. It does not replace a construction drawing. For structural engineers who need a floor-side beam comparison. Forces, reinforcement, and material quantities are estimates. They do not replace a code check, a drawing, or a signed issue.