Springback Conduit Bender

Recalculate remaining conduit marks from the bend you measured, with limits shown. Enter two tape readings along the bent leg for supported offset and saddle corrections. Read numbered marks from one end of the pipe, and open Show the math to inspect the calculation. Keep your own bender profiles on the phone. Enter take-up and deduct from your tool or measurements, with source notes visible. User-entered profiles are unverified. Measure what happened before planning what comes next. Supported four-point saddle workflows distinguish provisional marks from determined ones, and show the remaining constraints. A result within measurement noise does not promise an improvement your reading cannot establish. Use fractional-inch entries and return to saved work. Calculations run locally, with no account or subscription. Opening support and privacy pages requires a connection. Correction applies to offsets and saddles, not every bend type. Stub-up and back-to-back provide bounded procedures; segmented bends provide angle bookkeeping, not a numerical layout. No physical accuracy, tolerance, universal tool-fit or superiority is claimed. Check your first bend on a scrap before trusting any calculator, including this one.