Conduit Bend Sheet

Conduit measurements, clearly worked out. Enter your dimensions, check the geometry and keep a readable layout with your field notes. Conduit Bend Sheet brings offset, rolling offset and segment calculations into three focused worksheets. ENTER INCH FRACTIONS Type a decimal, a simple fraction such as 3/8, or a mixed fraction such as 6 3/8 for rise, side offset and centerline radius. Valid fraction entries show an approximate decimal preview. Sweep stays a decimal entry; the number of shots stays a whole number. OFFSET Calculate mark spacing, geometric shrink and the angle multiplier from rise and bend angle. ROLLING OFFSET Combine rise and side offset to calculate the true offset, mark spacing, roll angle and geometric shrink. SEGMENT BEND Use centerline radius, total sweep and the number of equal shots to calculate developed arc length, spacing along the arc, bend angle per shot and the end-to-end chord. KEEP THE WHOLE LAYOUT Save inputs, results and the full field note together. Browse saved layouts and share their text through the system share sheet. Earlier saved summaries remain as originally written. Measurements use inches and degrees. Fraction input accepts unsigned values within each field's range; decimal input uses a dot and up to six decimal places. Displayed inch fractions are rounded to the nearest 1/16 inch, and decimal previews and results are approximate. Fraction entry does not limit input to 1/16-inch increments. These are geometric estimates. Shrink is not a manufacturer-specific take-up or a rounded bender-table value. Compare the layout with your bender manual and actual job dimensions. Works locally on iPhone and iPad. Choose English or Korean in Settings. No account, subscription or in-app purchase is required.